✅Latency setting

In the bottom of the Laser Overview panel, you'll see a slider labelled Latency(ms).

The default latency setting of 150ms should be fine for most cases but if you are having network issues you may want to try to increase it.

The complicated explanation

In short, it's the maximum time between Liberation creating a frame, and the laser starting to output it. If you increase this value then you may notice a slight delay between Liberation and your laser output.

The benefit of a longer frame latency is that Liberation can fill up the laser controllers' buffers with content as soon as possible; if there is congestion on the network the controller is less likely to run out of points.